Table of Contents
Advertisement
en | RE3-RX receiver
34
RFPower
AutoOFF
KeyLock
Mic
Display
SYNC
Config
Save
Settings
Exit
Without
Save
7.3.11
Adjusting receiver volume
Setting the receiver output gain through menu item 6, Volume sets the gain leaving the
receiver and arriving at the destination circuit; either a microphone preamp, or a line in
preamp.
Press the ▼ button to scroll down to Volume from the main
1
menu. Select by pressing SET to enter the Volume screen.
The display shows the current volume setting in dB of
2
attenuation where 0 dB is the highest output volume, and -50
is the lowest output volume before mute.
Use the ▲ and ▼ buttons to adjust to the desired volume.
Pressing ▲ increases the volume by 1 dB (press and hold the
▲ button quickly increases the value) and pressing
3
▼decreases the volume by 1 dB (press and hold ▼ button
quickly decreases the value).
2021.06 | 3 | F.01U.362.808
Selects transmitter RF output power. This option is
band specific.
NOTE: 8M Band is not adjustable.
Assigns a time period for the transmitter to
automatically turn off once mute is engaged to
conserve battery life.
Prevents unwanted tampering with, or changes to
transmitter parameter settings.
Selects the tuning information displayed on the
transmitter home screen.
Allows selection of MicConfig items synced to the
transmitter during SYNC operation. Scroll with the ▼
and ▲ buttons. Select or deselect using SET.
Saves setting changes and exits to main menu.
Exits to the main menu without saving changes.
Installation manual
RE3 UHF Wireless
Lo or High
Off, 1 minute, 10
minutes, and 30
minutes
Off or On
Freq. or GP/CH
Electro-Voice
Advertisement
Table of Contents
