Table of Contents
Advertisement
en | RE3-RX receiver
30
7.3.7
Manually setting frequency
Setting custom frequencies manually does not benefit from the scan function of locating
clear channels. It is important to note that manually entered custom frequencies may
experience interference, which can be avoided by using the scan function.
Press the ▼ button to scroll down to Frequency on the main
1
menu. Select by pressing SET to enter the Setup Frequency
screen.
The three digits to the left of the decimal are in millions (MHz)
and are highlighted. Pressing ▲ increases frequency in
increments of 1 MHz per press, pressing ▼decreases
2
frequency in increments of 1 MHz per press. Press SET to
move to next set of three digits.
The three digits to the right of the decimal are in thousands
(kHz). Pressing ▲ increases frequency in increments of 25
kHz per press, ▼decreases frequency in increments of 25
3
kHz per press.
The G:__ and CH:__ under the frequency will populate when
a preset group and channel match the frequency dialed in.
Press SET to save the custom frequency and to exit to the
4
main menu.
Either scroll ▼down to Exit and press SET, or briefly press
SYNC on the receiver front panel to return to the home
5
screen. The selected custom Frequency displays on the
home screen.
7.3.8
Manually setting group and channel
Setting group and channel manually does not benefit from the scan function of locating
clear channels. It is important to note that manually entered group/channel combination
may experience interference, which can be avoided by using the scan function.
Press the ▼ button to scroll down to Group/Channel on the
main menu. Select by pressing SET to enter the Setup Group
1
screen.
2021.06 | 3 | F.01U.362.808
Installation manual
RE3 UHF Wireless
OR
Electro-Voice
Advertisement
Table of Contents
