Table of Contents
Advertisement
KPCI-PIO96 User's Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
NOTE
When wiring the mating connector, make sure that the ribbon cable is
long enough. When the mating connector is inserted at the front of the
board, in connector J102, connection points must be locatable
outside the rear of the computer. See Figure 3-2.
2. Turn OFF the host computer.
3. Remove the KPCI-PIO96 board.
4. Insert the test connector or cable assembly/terminal accessory into the board connector
designated in Table 5-5. (For connector locations, see Figure 3-2.) Feed the cable out through
the slot in the mounting bracket.
Table 5-5
Where to insert the output set test mating connector
If you are testing this group of A, B, and
C ports:
Port group 0
Port group 1
Port group 2
Port group 3
5. Reinstall the board in the PCI slot.
6. Turn ON the host computer and boot Windows 95®.
7. Click the Windows 95 Start tab.
8. Start the PIO Control Panel as follows:
a. In the Start menu, click Programs.
b. Find the DriverLINX Test Panels folder, under which you should find the PIO
Panel entry.
c. Click on the PIO Panel entry.
The PIO Control Panel should appear. See the example in Figure 5-9.
Troubleshooting
Then plug the loop-back connector into
this KPCI-PIO96 board I/O connector
J102
J103
J104
J105
5-17
Advertisement
Table of Contents
