Table of Contents
Advertisement
Figure D3-2 Setup mode change confirmation dialog box
Clicking the [OK] button navigates to the login window shown in Figure D2-3. Log in again and
setup will start up in Edit mode.
Clicking the [Cancel] button terminates the mode switching.
Setup starts up in Display mode even if the mode was Edit at the last logoff; so, it is necessary to
change modes every time the YFGW510 setting modification is required.
If configuration have been completed, restart the YFGW510 click the Restart button.
For other button functions, see D3.4 Maintenance.
IMPORTANT
Wait at least one minute after power-on, change to Edit mode YFGW510.
If you change to Edit mode at less than one minute may not start correctly.
In this case, restart the YFGW510.
<D3. Configuration Method>
D3-3
FD0302.ai
IM 01W02E01-01EN
Advertisement
Table of Contents
