Vigilantplant WFC009 User Manual page 50

Wiring of wireless LAN antenna and improvement of environmental
■
resistance
 Specification of extension cable for wireless LAN antenna
(Use only the cables included as option.)
•
Specification: 8D-SFA(PE)
•
Outside Diameter: 11.1 mm
•
Minimum Bend Radius: 67 mm (when fixing)
•
Cable End Treatment: N type connector, one end is male and the other is female.
* "When fixing" shows the bending radius for fixing (the state is maintained for a long time).
When wiring" shows the bending radius while checking the wiring position. This bending
radius is set larger than that for fixing in order to prevent damage to the cable because the
cable is likely to be repeatedly bent when checking the final wiring position.
 Wiring procedure of wireless LAN antenna
1. Use the provided extension antenna cable to connect the antenna connector with the external
antenna. Tighten the connector of the antenna extension cable with a torque of 2 to 3 N∙m.
Refer to the specification about the limitation of bend radius when fixing or wiring.
2. When using two extension cables, the provided arrester should be inserted between these
cables.
3. Before the wiring work, confirm the polarities (male/female) of the connectors of antenna,
extension antenna cable, and arrester.
Tighten the connector of the antenna extension cable with a torque of 2 to 3 N∙m.
167 mm (when wiring)
YFGW510 does not transmit at the same time from any antenna.
Figure C5-13 Wiring of wireless LAN antenna (single communications)
C5-15
<C5. Wiring>
IM 01W02E01-01EN