Table of Contents
Advertisement
l Optical network cable connection procedure
Connect the optical network cable in the following procedure.
1.
Insert the optical network cable through the YFGW510 network cable gland.
2.
Insert the connector through the YFGW510 connection and screw in the cable gland.
3.
Connect the optical network cable to the SC connector of the device. Do not bend the opti-
cal network cable at a sharp angle.
4.
The optical network cable consists of a pair of wires. One wire is used for sending signals
and the other for receiving signals (TX/RX). The polarity of the YFGW510 SC connector is
indicated on the connector label. If polarity is indicated, follow the indication. If not, the wires
can be connected to either port. The polarity can be easily changed on YFGW610.
Figure C5-4 Connecting optical network cable
C5-6
<C5. Wiring>
SC connector
label for connection
Cable gland for
Network Cable
Optical network cable
FC0504.ai
IM 01W02E01-01EN
Advertisement
Table of Contents
