Parameter Modification; Checking The Operating State - OEG 650 001 330 Installation And Operating Instruction

Click mode button
and select the button "System parameters". Then enter the password "99" to modify the
parameters.
Attention:
Parameter modifi cations are only allowed to be made by competent technical
experts. Wrong settings can cause serious damages to the heat pump.
Refer to chapter 4.8 for a list of all parameters.
Click mode button
and select the button "Operating state and errors" to check the "Refrigerant circuit" and
the "Hydraulic circuit". Thereby, you will be provided with the performance data and the
operating state.
Home
Ambient
temperature
Fan 1 speed
Fan2 speed
Condensation temperature
Evaporation temperature
IPM temperature
Multi-functional DC inverter air/water heat pump
Hydraulic circuit
Refrigerant circuit
Out door temp:
21
0.586
Ps:
3.9
Ts:
4.5
Tc:
1: 0 r/min
2: 0 r/min
0.1
TH
-5.2
TL
55.0
TIPM
Low pressure
Suction temperature
Refrigerant circuit
Refrigerant circuit
Room temp:
5.1
0.000
T
out
Pd:
Td:
24.0
200
P
15.3
15.1
50 Hz
Ty:
T
2 A in
Discharge gas temperature
High pressure
Coil temperature
Parameter modifi cation
Checking the operating
Back
i
Error list
Room temperature
Flow temperature
:
16.3
EEV steps
Return temperature
Tube temperature of heat
exchanger
:
Compressor frequency
Compressor current
Software version for PCB
1.02
1.00
Software version for control
67
4.4.2.6
4.4.2.7
state
GB