Intended Use; General Safety Regulations; Scope Of Delivery - OEG 650 001 330 Installation And Operating Instruction

This unit is a highly efficient monobloc air/water heat pump for outdoor installation. The
technical structure as well as all components are designed for a long service life even with
harsh weather conditions.
The unit is intended for space heating in detached and multi-family houses as well as in
small industrial businesses. Furthermore, it can be optionally used for space cooling and
DHW heating. Application range: -15 up to +45 °C. It can be safely operated after the user
has been instructed by qualified personnel and with due regard of these installation and
operating instructions. Any other use or one which goes beyond the intended use
specified in this manual shall be deemed as improper.
• For a safe operation of the unit, the user must have read and understood this manual
before commissioning.
• Keep this manual in a place that is accessible at all times.
• If you sell the unit or pass it on to somebody else, this manual must also be handed
over along with the unit.
• Please observe all safety instructions! Non-observance can endanger you and others.
• The unit must not be operated by children or people with limited cognitive abilities.
• Always switch off the external main switch before cleaning.
• Do not modify any safety or control devices.
• Do not pull, remove or twist any electrical cables exiting the unit.
• Do not insert any objects through the grid and into the fan.
• Repairs may only be carried out by qualified personnel under due regard of all
country-specific regulations.
• Have qualified personnel perform inspections and maintenances regularly.
• While being connected or during maintenance, live components must never be
accessible unattended.
• During and immediately after operation some components (e.g. pipes) can be
dangerously hot or cold. Do not touch such parts or, if necessary, only with suitable
protective equipment.
• We do not bear any liability for damages caused by failure to observe these operating
instructions.
• Works on the refrigerant circuit may only be carried out by qualified personnel
and are prohibited without a valid certificate of competence.
• Ready-to-connect heat pump incl. refrigerant
• Control unit with pre-assembled cable, cable length 20 m*
• Temperature sensor for DHW (domestic hot water), cable length 20 m*
• Temperature sensor T6, cable length 20 m*
• Water drain valve*
• Installation and operating instructions/manual
Always keep packaging material out of the reach of children!
* Inside the unit, behind the front panel. For opening the front panel, see chapter 3.4 on page 73 of this manual.
Multi-functional DC inverter air/water heat pump
47
General

Intended use

General safety regulations

Scope of delivery

1
1.1
1.2
1.3
GB