Cleaning The Sensors; Cleaning The Roller Brush & Suction Intake - Kalorik HUVI R1 Manual

• Put the filters back together in the dust bin, then reinsert the dust bin
into your HUVI.
NOTE: It is not recommended to clean the HEPA filter under running water
or get it wet.

CLEANING THE SENSORS

• Use a soft cloth to gently wipe the front sensor, floor sensors, and
charging contacts.
• Use a soft cloth to clean the signal sensor and charging pins on the
charging base.
CLEANING THE ROLLER BRUSH & SUCTION INTAKE
For optimal performance, clean the roller brush after a week of regular use.
Follow the instructions below to clean the roller brush.
• Push the two release tabs to unlock the sweep guard. Lift the roller
brush to remove.
www.KALORIK.com
Signal sensor
Charging pins
Floor sensors
Charging contacts
Front sensor
27
220131