Cleaning The Sensors; Cleaning The Roller Brush & Suction Intake - Kalorik HUVI R1 Manual

CLEANING THE SENSORS

• Use a soft cloth to gently wipe the front sensor, floor sensors, and
charging contacts.
• Use a soft cloth to clean the signal sensor and charging pins on the
charging base.
CLEANING THE ROLLER BRUSH & SUCTION INTAKE
For optimal performance, clean the roller brush after a week of regular use.
Follow the instructions below to clean the roller brush.
• Push the two release tabs to unlock the sweep guard. Lift the roller
brush to remove.
• Clean the roller brush as well as the suction intake with the provided
cleaning tool or by hand to remove any debris or obstructions.
• Reinstall the roller brush by inserting the fixed protruding end first so that
the brush clicks into place.
• Reattach the sweep guard. Press down to snap it into place.
www.KALORIK.com
Signal sensor
Charging pins
Floor sensors
Charging contacts
Front sensor
24
211104