Kalorik WFVC 43331 - Water Filtration Vacuum Cleaner Manual
  1. Manuals
  2. Brands
  3. Kalorik Manuals
  4. Vacuum Cleaner
  5. WFVC 43331
  6. User manual

Kalorik WFVC 43331 - Water Filtration Vacuum Cleaner Manual

Also See for WFVC 43331:

Advertisement

Table of Contents
Contents
Kalorik WFVC 43331 - Water Filtration Vacuum Cleaner Manual

PARTS DESCRIPTION

PARTS DESCRIPTION

  1. Dust brush
  2. Crevice tool
  3. Floor brush
  4. Adjustable tube
  5. Hook
  6. Curved tube
  7. Handle
  8. Main body
  9. Hose insert
  10. Barrel
  11. Base
  12. Caster
  13. Latch assembly
  14. Filtration assembly
  15. Power
  16. Hose
  17. Cord hook on base

IMPORTANT SAFEGUARDS

burn hazardburn hazard
To reduce the risk of fire, electric shock or injury, when using your appliance, basic safety precautions should always be followed, including the following:

  1. READ ALL INSTRUCTIONS
  2. Check that your mains voltage corresponds to that stated on the rating plate of the appliance or the adapter.
  3. Do not leave the appliance unattended when plugged in. Unplug from outlet when not in use and before servicing.
  4. Do not use outdoors.
  5. Do not allow to be used as a toy. Close attention is necessary when used by or near children.
  6. Please keep out of reach of children and pets. This product is not intended for use by children, by persons with reduced physical, sensory or mental capabilities, or lacking experience or knowledge, unless they have been given supervision or instruction concerning the use of the product, by a person responsible for their safety. Extra caution is always necessary when using this product.
  7. Use only as described in this manual. Use only manufacturer's recommended attachments.
  8. Never immerse the motor part in water or other liquids.
  9. Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged or left outdoors, return it to the service center of the manufacturer.
  10. Do not abuse the cord. Never carry the base by the cord or yank to disconnect from an outlet; instead grasp the plug and pull to disconnect.
  11. Keep the cord and the appliance away from heated or warm surfaces. Do not pull cord around sharp edges or corners. Do not close the door on the cord. Do not run appliance over cord.
  12. Do not store in places exposed to direct sunlight. Store the appliance only in a dry, cool place.
  13. Do not handle plug or appliance with wet hands.
  14. Use extra care when cleaning on stairs.
  15. Do not use on uneven surfaces. Do not tip or tilt the unit over when in use.
  16. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
  17. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
  18. Do not use without water in the tank.
  19. Turn off the unit before unplugging.
  20. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
  21. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
  22. Do not use to pick up liquids from containers, sinks, tubs, etc.
  23. shock hazard To avoid the risk of electrical shock, do not disassemble or attempt to repair the vacuum. Incorrect re-assembly or repair can cause a risk of electrical shock or injury to persons when the vacuum is used. If needed, return the appliance to the nearest authorized service facility for examination, repair, or adjustment.

SAVE THESE INSTRUCTIONS HOUSEHOLD USE ONLY

POLARIZED PLUG INSTRUCTIONS

shock hazard This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit into the polarized outlet only one way. If the plug does not properly fit into the outlet at first, reverse it. If it still does not fit, contact a competent qualified electrician. Do not attempt to modify the plug in any way.

UNPACKING AND ASSEMBLING

  1. Release the side latches and remove the main body.
  2. Lift the filtration assembly and unpack the casters and attachments from the barrel.
  3. Insert the casters into the holes in the base, in a turning motion. Then press down and make sure the casters are firmly attached.
  4. Put down the filtration assembly.
  5. Insert part 1 (on main body) into part 2 (of barrel). Then lock the latches.
    UNPACKING AND ASSEMBLING - Step 1
  6. Insert the hose insert into the barrel (for vacuuming function) or in the "blower" hole (1) located in the main body (for blower function). Gently rotate to the right to lock the hose in place and make sure it fits tightly.
  7. Insert the adjustable tube into the hook and set the tube in place. Fasten with the screw.
  8. Insert curved tube of the hose into the adjustable tube. Make sure the connection is tight.
    UNPACKING AND ASSEMBLING - Step 2
  9. Insert the end of the extension tube into the floor brush. Make sure the brush is tightly attached to the tube.

USING YOUR DEVICE

  • Assemble the vacuum cleaner before use.
  • ADD WATER TO THE BARREL BEFORE USE. Vacuuming without water can damage the motor.
  • DO NOT operate the vacuum when water level is below the "Working Level" line on the water tank.
  • Unwind the power cord and attach the cord to the hook located on the base (17). This allows more stability when the unit is rolled from one location to another.
  • Plug into a wall outlet.

Use: The water filtration vacuum cleaner can be used on dry and wet surfaces. To use as a wet pick-up vacuum, operate the unit on the wet surface as you would for a dry surface.


DO NOT overfill the water tank. The unit will stop working if the tank is full. If full, turn off and unplug the unit. Then empty the tank and clean. Refill with clean water at the "Working Level", then plug unit back in and continue working. DO NOT tip over.

On/Off Switch: Turn the unit on or off by pressing the power switch located on top of the main body.
USING YOUR DEVICE - Turning on/off

Air Flow Control: Adjust the suction level by moving the pusher up or down.

Floor Brush: The floor brush can be used for hard floors and carpets. Use the switch located on top of the brush to adjust the brush to the type of floor you are cleaning. Lower the brush for bare floors, raise it for carpets.

Adjustable Tube: Adjust the tube to the desired length by pushing the control switch. Release the button to lock.
USING YOUR DEVICE - Adjusting the tube

Motor thermostat: The vacuum cleaner is equipped with a motor protective thermostat. If the unit overheats, the thermal protector will shut off the unit. Should this occur, turn off the vacuum cleaner and unplug from the wall outlet. Allow the unit the cool before using again.

USING THE ACCESSORIES


Never attach or detach tools while the vacuum cleaner is running. Turn off and unplug the vacuum before attaching accessories.

Using the crevice tool

  • Use the crevice nozzle to clean narrow, hard-to-reach places, such as heater gaps, wall ends and corners, etc.
  • When using the crevice tool, remove the floor brush and insert the crevice tool directly into the extension tube.

Using the dust brush

  • Use the dust brush to clean lamps, blinds, shelves, upholstery and baseboards.
  • When using the dust brush, remove the floor brush and insert the dust brush directly into the extension tube.

CLEANING AND MAINTENANCE

  1. To empty the dirty water from your vacuum cleaner, release the latches and remove the main body and filtration assembly.
    Note: Make sure to remove the hose before releasing the latches.
  2. Pour the dirty water in a bucket or in the toilet. Then, rinse under clear water.
  3. Remove the sponges from the filtration assembly and rinse them under clean water.

To clean the cyclone generator: Remove the cyclone generator from the filtration assembly and rinse under clear water.

To clean the filter: Remove the filter from the main body and rinse under clear water. Let the filter air dry before putting back into place.

Notes:

  • Do not wash the filter in the dishwasher or in the washing machine. Do not use a hair dryer to dry the filter.
  • Always make sure the filter is in place before operating the appliance. Never use without the filter.
  • The filter should be cleaned twice a year. If visibly dirty, clean it at once. Replace the filter if damaged.
  • To replace the filters, please follow instructions provided in the separate installation guide.

STORAGE: Wrap the power cord around the main body. Insert the hook of the adjustable tube into the side of the main body. Then, insert the dust brush and crevice tool into the base.

TROUBLESHOOTING

ISSUE POSSIBLE REASON POSSIBLE SOLUTION

The device won't run
  1. Switch button is not on.
  2. Power cord is not firmly plugged into the outlet.
  3. Thermal protector is activated.
  4. There is too much water in the barrel.
  1. Turn the switch button On.
  2. Check that the plug is inserted firmly into the electrical outlet.
  3. Allow cleaner to cool.
  4. Remove some of the water.

Suction is reduced
  1. The hose or tube is clogged.
  2. Filter is clogged.
  3. Floor brush is clogged.
  1. Clean tube and/or hose.
  2. Clean the filter.
  3. Check floor brush and clean if necessary.

CAUTION

  • Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
  • Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.

www.KALORIK.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Kalorik WFVC 43331 - Water Filtration Vacuum Cleaner Manual

Advertisement

Need Assistance?

Do you have a question about the WFVC 43331 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Related Manuals for Kalorik WFVC 43331

Save Article as PDF

Table of Contents