Related Manuals for Wilson Electronics weBoost DRIVE 4G-X OTR 470210R
Summary of Contents for Wilson Electronics weBoost DRIVE 4G-X OTR 470210R
- Page 1 A WILSON ELECTRONICS, LLC COMPANY DRIVE 4G-X OTR Mobile Cellular Signal Booster Kit Truck Edition User Manual support.weboost.com 866.294.1660 NEED HELP?
-
Page 2: Table Of Contents
_____ Index Package Content Quick Installation Signal Booster Specifi cations Frequently Asked Questions Safety Guidelines Light Patterns Troubleshooting Mobile Antenna Kit Options Warranty... -
Page 3: Package Content
________ Package Content Installation Instructions for the Following weBoost Signal Booster: DRIVE 4G-X™ OTR 700 MHz Band 12/17 & 13 800 / 1900 (Excluding B25) AWS (1700 / 2100) Drive 4G-X 4G-OTR Slim Low Mounting DC Power Signal Antenna & Profile Bracket Supply... -
Page 4: Quick Installation
________ Quick Installation Remove 4G-OTR ANTENNA INSTALLATION Select a location on one of the mirror rails to mount Remove the 4G-OTR Antenna that is: Remove • At least 12 inches from any other antennas. • Free of obstructions. 4G-OTR Antenna •... - Page 5 Slim Low Profile 4G-OTR Antenna Antenna CONNECT COAX CABLES TO DRIVE 4G-X Select a location for the Drive 4G-X that is free from excessive heat, direct sunlight and moisture and that has proper ventilation. Good locations include underneath a seat or under the dashboard. Connect the cable from the 4G-OTR Antenna to the port labeled “Outside Antenna”...
-
Page 6: Signal Booster Specifi Cations
______ Specifi cations Drive 4G-X OTR Product Number U470010 Model Number 460021 FCC ID: PWO460021 4726A-460021 Connectors SMA-Female Antenna Impedance 50 Ohms Frequency 699-716 MHz, 729-756 MHz, 777-786 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755 MHz/2110-2155 MHz 700 MHz 700 MHz 800 MHz 1900 MHz 1700/2100 MHz... -
Page 7: Frequently Asked Questions
(SPECIFICATIONS cont.) Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for fi... -
Page 8: Safety Guidelines
Safety Guidelines Warnings Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment. The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less than 150 degrees Fahrenheit). It is not intended for use in attics or similar locations subject to temperatures in excess of that range. -
Page 9: Light Patterns
Light Patterns SOLID GREEN — This indicates that your booster is functioning properly and there are no issues with installation. BLINKING RED, THEN SOLID GREEN —This indicates that one or more of the booster bands has reduced power due to a feedback loop condition called oscillation. -
Page 10: Mobile Antenna Kit Options
(TROUBLESHOOTING cont.) Light Off If the Drive 4G-X Signal Booster’s light is off, verify your power supply has power. NOTE: The Signal Booster can be reset by disconnecting and reconnecting the power supply. After troubleshooting you must initiate a new power cycle by disconnecting and then reconnecting power to the Booster. -
Page 11: Warranty
Warranty 2 YEAR WARRANTY weBoost Signal Boosters are warranted for two (2) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weboost. - Page 12 3301 East Deseret Drive, St. George, UT www.weboost.com | support.weboost.com Copyright © 2015 weBoost. All rights reserved. weBoost products covered by U.S. patent(s) and pending application(s) For patents go to: weboost.com/us/patents NOT AFFILIATED WITH WILSON ANTENNA 111923_Rev 03_07.27.16...