Transmitting By Specifying A Voip Gateway - Gestetner F104 Supplementary Manual

Using IP-Fax Functions
Transmitting by Specifying a
VoIP Gateway
This section describes how to send fax
messages through your network to
ordinary G3 fax machines connected
to the public telephone lines via a
VoIP gateway.
A A A A
Set the original, and then select
the scan settings as necessary.
B B B B
Press the user function key ({ { { { F1} } } }
to { { { { F10} } } } ) assigned to the Internet
FAX function.
5
The display for entering an ad-
dress appears.
Note
❒ On Type 2 machines, the Inter-
net FAX function is pre-as-
signed to the { { { { F5} } } } key.
❒ Use the following to specify an
IP address or host name with-
out pressing the user function
key:
• Quick Dial, Speed Dial or
Group Dial assigned to the
destination IP address
• The Redial function
Reference
Chapter 2 "Dialing", Basic Fea-
tures
Chapter 3 "Redial", Advanced
Features
100
If the Network Transmission Auto
Check Function Is Turned Off
If the Network Transmission Auto
Check function is set to "Off" with
user parameters, select "IP-Fax Ad-
dress" in the display that appears.
For information about changing
this setting, see p.166 "User Pa-
rameters" (switch 32, bit 1).
A Press 0 0 0 0 or 1 1 1 1 key to display "2.
IP-Fax Address".
B Press the { { { { OK} } } } key.
C C C C
Enter the G3 fax number of the re-
ceiver using the number keys,
and then press the { { { { OK} } } } key.
When the Network Transmission
Auto Check Function is set to On:
ZHMS170E
When the Network Transmission
Auto Check Function is set to Off:
D D D D
Press the 0 0 0 0 or 1 1 1 1 key to display
"2. IP-Fax Address".
Note
❒ If the Network Transmission
Auto Check function is turned
off, the display does not appear.
Proceed to step
"User Parameters" (switch 32,
bit 1).
F
. See p.166