Emptying Waste Ink Tank - MUTOH ValueJet VJ-628 Operation Manual

Emptying waste ink tank

3

Emptying waste ink tank

When a certain amount of waste fluid has been collected in the waste ink tank, the error LED on the operation panel of this
product turns on with beep sounds.
Drain waste ink inside the waste ink tank to PET bottle, and discharge.
CAUTION
Be cautious that ink does not get into your eye or make a contact with your skin. Wear groves.
When ink gets into your eye or make a contact with your skin, wash with water immediately. If left as it is, it
may cause red eye or light inflammation. If it is necessary, please see your doctor immediately.
Important!
When moving this product, always empty the waste ink tank even moving short distance.
If ink splashes inside the waste ink tank while being moved, it can cause damage.
Procedure
[1]
[2] Launch MSM and display the remote panel.
"Launching/Displaying/Exiting MUTOH Status Monitor (MSM)" on page 11
[3] Check [Status Information] in the [Printer Status] tab.
• A message indicating that the waste ink tank is full is displayed.
[4]
Prepare a container like PET bottle to drain the waste ink.
Important!
The capacity of waste ink tank is 1,400 ml. Make sure to prepare a container that has enough capacity when discharging waste ink.
56 Replacing ink cartridge
Check the error LED is flashing.