Veriphy - ZyXEL Communications RGS Series User Manual

5.5.3

VeriPHY

Press
can take approximately 15 seconds. When completed, the page refreshes automatically, and you can view the
cable diagnostics results in the cable status table. Note that VeriPHY is only accurate for cables of length 7 - 140
meters.
10 and 100 Mbps ports will be linked down while running VeriPHY. Therefore, running VeriPHY on a 10 or 100
Mbps management port will cause the switch to stop responding until VeriPHY is complete.
After pressing
Object
Port
Cable Status
to run the diagnostics. This will take approximately 5 seconds. If all ports are selected, this
, following table show up.
The port where you are requesting VeriPHY Cable Diagnostics.
Port:
Port number.
Pair:
The status of the cable pair.
Description
239