Remote 1 In> Terminal; Operating [Menu Lock Password] - Panasonic PT-MW630 Operating Instructions Manual

<REMOTE 1 IN> terminal
The projector can be remotely controlled (contact control) by the control board that is located far away form the
projector where the signal from the remote control does not reach.
Use the <REMOTE 1 IN> terminal on the connecting terminals of the projector to connect to the control board.
Installation locations in meeting rooms, etc.
Pin assignments and signal names
D-Sub 9-pin
Outside view
(6) (9)
(1) (5)
Attention
f When controlling, make sure to short-circuit pins (1) and (9).
f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g Power <v/b> button, <SHUTTER> button
f When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g Power <v/b> button, <INPUT SELECT> button, <RGB1/2> button, <HDMI 1> button, <HDMI 2> button, <DIGITAL LINK> button,
<VIDEO> button, <NETWORK/USB> button, <SHUTTER> button
Note
f Setting of the pin (2) to pin (8) can be changed when the [PROJECTOR SETUP] menu → [REMOTE1 MODE] is set to [USER].
(x page 122)

Operating [MENU LOCK PASSWORD]

To initialize your password, consult your distributor.
Chapter 7 Appendix — Technical information
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Remote control
Remote control/contact control
Standby
RGB1
RGB2
VIDEO
Remote control board in another location
Signal name Open (H)
GND ―
POWER OFF
RGB1 Other
RGB2 Other
VIDEO Other
HDMI1 Other
HDMI2 Other
SHUTTER OFF
Controlled by remote
RST/SET
control
Contact control
Lit
Light source
HDMI1
HDMI2
Short (L)
GND
ON
RGB1
RGB2
VIDEO
HDMI1
HDMI2
ON
Controlled by external
contact
ENGLISH - 217