Panasonic PT-MW630 Operating Instructions Manual page 115

2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [SIGNAL DETECTION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f When the [PROJECTOR SETUP] menu → [LightID] is set to [EXTERNAL CONTROL] or [INTERNAL ID], [SIGNAL DETECTION] is set to
[OFF].
f The [SIGNAL DETECTION] function will also operate during MEMORY VIEWER, MIRRORING, or Panasonic APPLICATION input. In the
following cases, the projector will determine that there is no input signal.
g MEMORY VIEWER input: USB memory is not inserted in the <VIEWER/PAIRING> terminal
g MIRRORING input, Panasonic APPLICATION input: There is no connection from the computer, etc.
Setting [POWER MANAGEMENT]
This is a function to set the power of the projector to standby state or ready state automatically when there
is no input signal for specific time. Selection of standby state or the ready state, and the time for the power
management function to operate can be set.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [POWER MANAGEMENT].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[SHUT DOWN]
[OFF]
[READY]
f Proceed to Step 5) when anything other than [OFF] is selected.
5) Press the <ENTER> button.
f The [POWER MANAGEMENT] screen is displayed.
6) Press qw to set the time for [TIMER].
f The setting time will switch each time you press the button.
f The time for the power management function to operate can be set from 5 minutes to 120 minutes in five-
minute interval.
Note
f The power management function will also operate in MEMORY VIEWER, MIRRORING, and Panasonic APPLICATION inputs. The condition
to determine that there is no input signal is as follows.
g MEMORY VIEWER input: USB memory is not attached to the <VIEWER/PAIRING> terminal
g MIRRORING input, Panasonic APPLICATION input: There is no connection from the computer, etc.
Setting [STANDBY MODE]
Set the power consumption during standby and whether to enable the [QUICK STARTUP] function.
1) Press as to select [ECO MANAGEMENT].
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the [SIGNAL DETECTION] function.
Enables the [SIGNAL DETECTION] function.
The countdown timer is displayed when the signal input is not present for 30 seconds, and the light
source is turned off, and goes into standby after cooling when the time set in [TIMER] has elapsed.
Disables the power management function.
The countdown timer is displayed when the signal input is not present for 30 seconds, and the
light source is turned off, and goes into ready state after cooling when the time set in [TIMER] has
elapsed.
The light source will turn on and starts projection when a signal is input or the button is operated while
in ready state.
ENGLISH - 115