Panasonic PT-MW630 Operating Instructions Manual page 200

2) Remove the air filter cover. (Fig. 1)
f Turn the air filter cover fixing screw (x 1) counterclockwise with a Phillips screwdriver until it turns freely, and
remove the air filter cover by placing a finger in the depressed section and pull it out slowly in the direction
of the arrow.
f When pulling out the air filter cover, make sure to place a hand on the air filter cover. Pulling it out too
rapidly may cause the air filter cover to fall.
3) Pull out the air filter unit. (Fig. 2)
f Slightly push the grip of the air filter unit inward in the direction of the arrow, remove from the tabs on the
projector body, and pull out the air filter unit.
f After pulling out the air filter unit, remove any foreign object and dust from the air filter unit compartment
and the projector's air intake port.
Performing maintenance of the air filter unit
Remove the air filter unit in advance with the procedure for "Removing the air filter unit" (x page 199) described
previously.
1) Wash the air filter unit. (Fig. 1)
i) Soak the air filter unit in cold or warm water and then lightly rinse it.
f Do not use cleaning tools such as brushes.
f When rinsing, hold the frame of the air filter unit without putting strong pressure on the filter unit.
ii) Rinse the air filter unit two to three times using fresh water each time.
f Insufficient rinsing may result in odors.
2) Dry the air filter unit. (Fig. 2)
f Let the air filter unit naturally dry off in a well-ventilated place where there is little dust and is not exposed to
direct sunlight.
f Do not dry using drying devices such as dryers.
f Once the air filter is dried, proceed to "Attaching the air filter unit" (x page 200) next.
Attaching the air filter unit
1) Attach the air filter unit to the projector.
f Attach the air filter unit in the reverse procedure of Step 3) in "Removing the air filter unit" (x page 199).
f Push in the air filter unit all the way in until it clicks.
2) Attach the air filter cover.
f Close the air filter cover in the reverse procedure of Step 2) in "Removing the air filter unit" (x page 199),
and press it in all the way until it clicks.
f Securely tighten the air filter cover fixing screw (x 1) using a Phillips screwdriver.
200 - ENGLISH
Chapter 6 Maintenance — Maintenance/replacement
Fig. 1 Fig. 2