Mitsubishi Electric NZ2GFCE-60DAV8 User Manual page 42

■NZ2GFCE-60DAI8
e-CON external appearance
Do not wire the NC terminals. Incorrect wiring may cause malfunction or failure of the module.
Precautions
To obtain the maximum performance from the functions of the D/A converter module and improve the system reliability, an
external wiring with high durability against noise is required.
The following shows wiring precautions.
• Use separate cables for the AC control circuit and the external I/O signals of the D/A converter module to avoid the
influence of the AC side surges or induction.
• Do not install cables near or bundle cables with any main circuit lines, high voltage lines, or load cables for equipment other
than the programmable controller. Keep cables an adequate distance away from any high frequency circuit such as a main
load circuit for high voltage lines or inverters. Noise, surges, or induction may affect the system.
• Ground shielded wires or shielded cables based on single-point ground on the programmable controller side. However,
depending on the external noise conditions, it may be better to ground them externally.
5 INSTALLATION AND WIRING
40
5.4 Wiring
Downloaded from ManualsNet.com search engine
Terminal layout
Channel Signal name
CH1 NC
CH2 NC
CH3 NC
CH4 NC
CH5 NC
CH6 NC
CH7 NC
CH8 NC
NC I-
NC I-
NC I-
NC I-
NC I-
NC I-
NC I-
NC I-
I+
I+
I+
I+
I+
I+
I+
I+