Table of Contents
Advertisement
Chapter 2 Getting Started — Installing/removing the projector
Preparing the adapter
1)
Set the phase selector switch on the adapter.
f Turn the phase selector switch on the supplied adapter and adjust the power phase (1, 2, or 3) according to your track system.
f The setting of the phase selector switch can be checked with the power phase indicator.
Phase selector switch
r Illustration of the adapter attached to the track system
Phase selector switch
Note
f The setting of the phase selector switch can be changed even when the adapter is attached to the track system.
f When the phase selector switch is set to "0", the adapter and the track system are not electrically connected.
f If you do not know which number to set the phase selector switch, consult the installation personnel of your track system.
Lever
Power phase indicator
Power connector
Power contacts
Locking fingers
Lever
Power phase indicator
Ground contact
Lever
Phase selector switch
Power connector
Ground contact
Power contacts
Locking fingers
Phase selector switch
ENGLISH - 31
Advertisement
Table of Contents
