Table of Contents
Advertisement
About your projector
Remote control
1
Remote control signal transmitter
2
Power <v/b> button
Turns on/off the power of the projector. (x page 44)
3
<Miracast> button
Switches the input to Miracast. (x page 49)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
Miracast.
4
<SIGNAGE> button
Switches the input to signage. (x page 49)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
signage.
5
<MEMORY VIEWER> button
Switches the input to Memory Viewer. (x page 49)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
Memory Viewer.
6
asqw buttons/<ENTER> button/<RETURN> button
Used to operate the menu screen. Also used when entering
[SECURITY PASSWORD].
7
<AV MUTE> button
Used to turn off the image and audio temporarily. (x page 54)
8
<DEFAULT> button
Resets the settings of the sub-menu to the factory defaults.
(x page 57)
9
<MENU> button
Displays the main menu. (x page 56)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Observe the following instructions that are indicated on the caution label at the back of the remote control:
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
Chapter 1 Preparation — About your projector
1
3
2
4
5
6
7
8
9
10
11
12
13
14
15
16
17
10 <ZOOM> button/<FOCUS> button
Displays the lens menu and adjusts the projection lens.
(x page 50)
11 <VOL+>/<VOL-> buttons
Adjusts the volume of audio output. (x page 54)
12 <LIGHTING/PROJECTOR> button
Switches the projection mode of the projector to lighting mode
or projector mode. (x page 49)
13 <Panasonic APP> button
Switches the input to Panasonic APPLICATION. (x page 49)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
Panasonic APPLICATION.
14 <HDMI> button
Switches the input to HDMI. (x page 49)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
HDMI.
15 <ID ALL> button
Used to simultaneously control all the projectors with a
single remote control in a multiple projector environment.
(x page 24)
16 <ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 24)
17 Number (<1> - <6>) buttons
Used in a multiple projector environment.
Used to enter ID number or password.
ENGLISH - 19
Advertisement
Table of Contents
