Table of Contents
Advertisement
Chapter 6 Maintenance — Light source/temperature indicators
Light source/temperature indicators
When an indicator lights up
If a problem should occur inside the projector, the light source indicator <LIGHT>/temperature indicator <TEMP> will inform you by lighting or
blinking. Check the status of the indicators and remedy the indicated problems as follows.
Attention
f Make sure to turn off the power before performing the procedure.
f Make sure to follow the procedure in "Turning off the projector" (x page 48) when switching off the projector.
f Check the status of the power supply with the power indicator <ON (G)/STANDBY (R)>. (x page 44)
Light source indicator <LIGHT>
Indicator status
The light source may not light
Status
properly.
Cause
Solution
Turn off the power of the track system and then turn it on again.
Note
f If the light source indicator <LIGHT> is still lighting or blinking after taking above measures, ask your dealer for repair.
ON(G)/
STANDBY(R)
LIGHT
TEMP
SD
Lighting in red
(projecting)
The light source does not light or has suddenly turned off.
Power indicator <ON (G)/STANDBY (R)>
Light source indicator <LIGHT>
Temperature indicator <TEMP>
Blinking in red
(2 times)
―
Blinking in red
(3 times)
ENGLISH - 199
Advertisement
Table of Contents
