Table of Contents
Advertisement
Chapter 2 Getting Started — Installing/removing the projector
Installing/removing the projector
This section describes the mounting method of the projector to the track system and the setting method of the orientation of the main unit.
Before mounting
The track systems compatible for mounting the projector are as follows.
Manufacturer
Name
Type No.
Attention
f Ensure that track system is installed per manufacturer's instructions.
f Before mounting/removing the projector, turn off the power of the track system.
f Mount the projector to the track system which is installed in the horizontal ceiling or beam and can withstand the weight of the projector
(x page 212).
Do not mount the projector to the following track systems.
g Track system that is installed in the wall surface or floor
g Track system that is installed in the sloping ceiling
g Track system that cannot withstand the load
f If it is hard to operate the lever on the track mount parts A/B when mounting the projector, remove the projector from the track system
without turning the lever forcibly, displace the projector slightly and mount it again.
Note
f The adapter of the projector cannot be mounted to the position of the tapping screw fixing the track system to the ceiling or beam.
f When multiple projectors are mounted side by side, the brightness or the color may differ due to individual differences, even when the model
number is the same.
f The model number of track system is subject to change without prior notice.
Preparing the adapter cover
1)
Attach the string to the adapter cover.
f Pass one end (with smaller ring) of the string through the hole of the adapter cover and attach it to the adapter cover as shown in the
figure.
30 - ENGLISH
XTS4100/XTS4200/XTS4300/XTS4400
Hole for attaching string
Nordic Aluminium
GLOBAL Trac Pro tracks
Advertisement
Table of Contents
