Gateway Solo 5100 Maintaining & Troubleshooting page 47

7. Insert the Windows NT 4.0 Video Driver disk in drive A:\ and click
Disk... .
8. The Install From Disk window appears. A:\ will be the default path listed.
Click .
OK
9. A dialog box appears showing the Chips Video Accelerator
Change Display
driver. Click OK .
10. A warning window appears stating the driver is a third-party driver and asks
if the installation should proceed. Click
11. Files will be copied, then a window appears stating the drivers were
successfully installed. Click
12. Close the Display Properties
13. Click Yes to restart the system for changes to take effect.
14. After restarting the computer, an
stating a new graphics driver has been installed and a display resolution must
be set. Click to remove the error message.
OK
15. The Display Properties
resolution and colors. Click
Colors or the color depth of your choice.
16. Move the
Desktop area
resolution to
1024 x 768
make sure your settings work.
17. Click Yes if you saw the test screen properly or make changes to the settings
and test again if the settings did not work.
18. Click
Apply , OK .
Windows NT audio drivers
When Windows NT is installed on a hard drive with a new Windows NT operating
system load, the audio chips are not properly detected. Use the following
instructions to install the audio drivers that support your Solo audio and game
ports. If the Solo System CD shipped with your system, you may use it to install the
driver instead of installing the drivers from diskette.
Yes .
.
OK
setup boxes and take out the disk.
Invalid Display Settings
window opens automatically. Set the display
Color palette list box arrow and click
(display resolution) slider to the right to adjust pixel
to get full use of the display area. Click
Have
window appears
65536
, to
Test OK
Chapter 4: Installing Drivers and Related Software 47