Gateway Solo 5100 Maintaining & Troubleshooting page 60

60 Maintaining and Troubleshooting Your Solo Notebook
8. Re-install the second PC Card. You should hear a two-tone beep, indicating
that the card is enabled.
9. To later use the port you disabled, go back into
the check in the
Disabled
use.
If the PC Card is still not configured correctly, try shutting down and restarting
your system.
If you are running the Windows 95 operating system, check the
that the setting for Plug and Play OS
If was set to no, then try Steps 1-9 again. If you are running the
Plug and Play OS
Windows NT operating system do not set the CMOS to
Device Manager
box. The port should be immediately available for
is set to Yes see "Advanced menu" on page 73.
and remove
BIOS Setup to see
.
Plug and Play OS