Security Menu - Gateway Solo 5100 Maintaining & Troubleshooting

Gateway solo 5100: supplementary guide
Hide thumbs Also See for Solo 5100:
Table of Contents

Advertisement

Caution!
Setting items on this menu to
incorrect values may cause
your system to malfunction.
Note:
The Setup menu screen shown
may differ somewhat from
that shown here. If there are
differences, follow the on-
screen instructions and helps.
74
Maintaining and Troubleshooting Your Solo Notebook
Main Advanced Security Power Boot Exit
Setup Warning
Setting items on this menu to
incorrect values may cause your
system to malfunction
Plug & Play O/S:
USB Keyboard
>PCI Configuration
>I/O Device Configuration
Local Bus IDE adapter:
Large Disk Access Mode:
>Audio Options Menu
F1 Help
Select Item -/+ Change Values
ESC Exits
Select Menu
Advanced menu
Press the <Esc> key to access the Exit menu and accept or discard changes. Press
<F9> to return to the factory defaults, or <No> to return to the previous settings.
Use the right arrow key to move over to the next menu.

Security menu

The Security menu primarily lets you set passwords, either Supervisor or user, that
limit access to your BIOS setup and thus protect your system.
1. Start your notebook.
2. Press the <F2> key when prompted to do so. The "Entering Setup..."
message briefly shows and then the Main menu appears.
PhoenixBIOS Setup Utility
[Yes]
[Disabled]
[Enabled]
[Both]
[DOS]
F9 Setup Default
Enter Select > Sub-Menu F10 Save and Exit
To access the Setup menus
Item Specific Help
Select 'Yes' if you are
using a Plug & Play
capable operating system.
Select 'No' if you need
the BIOS to configure
non-boot devices.

Advertisement

Table of Contents
loading

Table of Contents