Exit Menu - Gateway Solo 5100 Maintaining & Troubleshooting

Main Advanced Security Power Boot Exit
1. [Diskette Drive]
2. [Hard Drive]
3. [CD ROM Drive]
F1 Help Select Item -/+ Change Values
ESC Exits Select Menu
Boot menu

Exit menu

The Exit menu contains the options available once you have made changes to the
Setup menus. Use the arrow keys to make your selection and follow all screen
prompts.
Main Advanced Security Power Boot Exit
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
F1 Help ¦Ø Select Item -/+ Change Values
ESC Exits ¨Æ Select Menu
Exit menu
Press the <Esc> key to access the Exit menu and accept or discard changes. Press
<F9> to return to the factory defaults, or <No> to return to the previous settings.
Use the right arrow key to move over to the next menu.
PhoenixBIOS Setup Utility
F9 Setup Default
Enter Select > Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
F9 Setup Default
Enter Select > Sub-Menu F10 Save and Exit
Item Specific Help
Use <Up Arrow> or
<Down Arrow> to select a
device, then press <+> to
move it up the list or <->
to move it down the list.
Press <Esc> to exit this
menu.
Item Specific Help
Exit System Setup and
save your changes to
CMOS.
Note:
The Setup menu screen shown
may differ somewhat from
that shown here. If there are
differences, follow the on-
screen instructions and helps.
Note:
The Setup menu screen shown
may differ somewhat from
that shown here. If there are
differences, follow the on-
screen instructions and helps.
Chapter 8: BIOS Setup 77