Installing Software Updates - Gateway Solo 5100 Maintaining & Troubleshooting

15. Once the update is complete, click
16. Click
Start , Shutdown
When completed, the correct USB driver appears in the Device Manager as
shown below.
Properly installed USB drivers shown in the Device Manager

Installing software updates

Install the following software updates to complete the system install.
Installing the UHCD.SYS update
1. Place the uhcdupd.exe driver disk in drive A.
2. Click
Start , Run , then type:
a:\ uhcdupd.exe
then click OK .
3. Click Yes to continue with the installation.
OK .
, Restart the computer? to initialize the USB installation.
Chapter 4: Installing Drivers and Related Software 43