Gateway Solo 5100 Maintaining & Troubleshooting page 21

Swapping to the floppy module
1. Press the power button to shutdown the system. Remove the CD-ROM
module and install the floppy drive module.
2. Press the power button to restart your system.
3. When prompted to enter the mm/dd/yy, press <Enter>. You can set the clock
later after Windows is installed.
4. When prompted to enter the time. Press <Enter>. You can set the time later
after Windows is installed.
Copying .vxd and .inf files to the hard drive
1. Insert the Solo 5100 VXD / INF diskette.
2. Type:
a:\
then press <Enter>
3. Type:
copy *.* c:\win95
then press <Enter>
4. Press the power button to shutdown the system.
Starting Windows 95 Setup program
1. Press the power button to restart your system.
2. When prompted to enter the mm/dd/yy, press <Enter>. You can set the clock
later when Windows is installed.
3. When prompted to enter the time. Press <Enter>. You can set the time later
after Windows is installed.
Chapter 2: Reinstalling Windows 95 System Software 21