Advanced Menu - Gateway Solo 5100 Maintaining & Troubleshooting

Main Advanced Security Power Boot Exit
System Time:
System Date:
Floppy Disk Drive A:
Floppy Disk Drive B:
>Primary Master:
>Secondary Master:
Memory Cache:
System Memory:
>System Information:
Numlock:
TV Out:
Display Device:
Text Mode Expansion:
Graphics Mode Expansion:
QuickBoot Mode:
Floppy check:
Boot-time Diagnostic Screen:
F1 Help Select Item -/+ Change Values
ESC Exits Select Menu
Main menu
Press the <Esc> key to access the Exit menu and accept or discard changes. Press
<F9> to return to the factory defaults, or <No> to return to the previous settings.
Use the right arrow key to move over to the next menu.

Advanced menu

The Advanced menu contains operating system, system allocation (IRQ and
register settings) and port assignment (COM and LPT) information.
1. Start your notebook.
2. Press the <F2> key when prompted to do so. The "Entering Setup..."
message briefly shows and then the Main menu appears.
3. Follow the instructions along the bottom of the menus to navigate through the
different options and menus. An Item Specific Help area providing additional
information is also located along the right side of each menu.
PhoenixBIOS Setup Utility
[HH:MM:SS]
[MM/DD/YYYY]
[1.44/1.25 MB 31/2"]
[Disabled]
[NNN MB]
[None]
[Enabled]
NNN KB
[Off]
[Disabled]
[Simultaneous]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
F9 Setup Default
Enter Select > Sub-Menu F10 Save and Exit
To access the Setup menus
Item Specific Help
Enter System Time.
<Tab>, <Shift-Tab>, or
<Enter> selects field.
Note:
The Setup menu screen shown
may differ somewhat from
that shown here. If there are
differences, follow the on-
screen instructions and helps.
Chapter 8: BIOS Setup 73