Table of Contents
Advertisement
Fixture properties
Factory default
When restoring factory defaults in the Q-10 Series, the following settings will be set:
•
DMX address = 1
•
DMX mode = Default mode (6 channel)
•
Startup mode = DMX
•
Display saver = Off
•
Flip screen = Off
•
RDM device label set to = Fixture type name
•
Internal program reset
Effects
Colors and LED Panels
The Q-10 Series features 2,048 RGB SMD LEDs and 2,048 white SMD LEDs divided in 8 individually controllable segments, which
generates wide-ranging color effects and pixel-mapping combinations for creative lighting designs.
The fixture can operate in RGB calibrated mode, which ensures that colors are compatible across the range of SGM fixtures.
However, the Q-10 also offers the ability to operate in RAW mode with full control of each color.
Color temperature correction
The Q-10 Series offers seamless CTC (color temperature correction) control from 2000° Kelvin - 10000° Kelvin.
Ultra high-speed strobe effect
The ultra high-speed strobe effect generates random strobe and pulse effects with variable speed.
Individual fixture settings
Flipping the OLED display (POI n.a.)
If the fixture is installed hanging upside down, it might be useful to flip the display so that it is easier to read.
To flip the display press ENTER and select SETTINGS → FLIP DISPLAY, or press the up and down buttons on the control panel at
the same time.
Setting the OLED display saver (POI n.a.)
By default the OLED display dims down after a short period when the control panel is not in use. The display can also be set to turn
off completely, especially when a pitch-black environment is required. Pressing any key will always turn on the display or restore it to
normal brightness.
To configure the display settings press ENTER → SETTINGS → DISPLAY SAVER.
NOTE: To avoid the risk of display deterioration caused by long term usage, it is recommended to select the setting → DISPLAY OFF.
Setting the fan mode
For operating environments where low-noise is a requirement or where the fixture will be operating in high temperatures, it is possible
to adjust the default fan speed to low or high by going to SETTINGS → FAN MODE in the menu.
NOTE: In POI version, the fan mode adjustment is possible through RDM.
12
Pixel 1
Pixel 3
Pixel 5
Pixel 7
Figure 13: Q-10 Pixel segments
Pixel 2
Pixel 4
Pixel 6
Pixel 8
Advertisement
Table of Contents
