Table of Contents
Advertisement
3.2.1 Use of Serial Flash
3.2.1.1 Onboard Serial Flash
The following sample programs can be found in the
folder.
•
SFLASH_INSPECT.c
serial flash chip. When the sample program starts running, it attempts to initialize a
serial flash chip on Serial Port B. Once a serial flash chip is found, the user can perform
two different commands to either print out the contents of a specified page or clear (set
to zero) all the bytes in a specified page.
—This program runs a simple Web server and stores a log of hits in
•
SFLASH_LOG.c
the serial flash. This log can be viewed and cleared from a browser.
3.2.1.2 SF1000 Serial Flash Card
The following sample program can be found in the
•
SERFLASHTEST.c
onstration. Install the Serial Flash card into socket J11 on the Prototyping Board. This
sample program demonstrates how to read and write from/to the Serial Flash card.
3.2.2 Serial Communication
The following sample programs can be found in the
•
FLOWCONTROL.C
Serial Port F for CTS/RTS with serial data coming from TxE (Serial Port E) at 115,200
bps. One character at a time is received and is displayed in the
To set up the Prototyping Board, you will need to tie
TxE and RxE together on the RS-232 header at J14,
and you will also tie TxF and RxF together as shown in
the diagram.
A repeating triangular pattern should print out in the
window. The program will periodically switch flow control on or off to demon-
STDIO
strate the effect of no flow control.
—This program demonstrates the use of parity modes by repeatedly sending
•
PARITY.C
byte values 0–127 from Serial Port E to Serial Port F. The program will switch between
generating parity or not on Serial Port E. Serial Port F will always be checking parity,
so parity errors should occur during every other sequence.
To set up the Prototyping Board, you will need to tie
TxE and RxF together on the RS-232 header at J14 as
shown in the diagram.
The Dynamic C
STDIO
sequence.
User's Manual
—This program is a handy utility for inspecting the contents of a
—An optional SF1000 Serial Flash card is required to run this dem-
—This program demonstrates hardware flow control by configuring
window will display the error
SAMPLES\RCM3300\SerialFlash
SAMPLES\RCM3300\SF1000
SAMPLES\RCM3300\SERIAL
STDIO
TxE RxE
TxE
RxE GND TxF
folder.
folder.
window.
GND
TxF RxF
485+ GND 485–
RxF
485+ GND 485–
19
Advertisement
Table of Contents
