Comparing The Rcm3309/Rcm3319 And Rcm3305/Rcm3315 - Rabbit RabbitCore RCM3305 User Manual

1.2 Comparing the RCM3309/RCM3319 and RCM3305/RCM3315

We can no longer obtain certain components for the RCM3305/RCM3315 RabbitCore
modules that support the originally specified -40°C to +70°C temperature range. Instead of
changing the design of the RCM3305/RCM3315 RabbitCore modules to handle available
components specified for the original temperature range, we decided to develop a new
product line — the RCM3309/RCM3319 — based on the RCM3900 RabbitCore modules
that were released for the same reason.
The RCM3309/RCM3319 modules are similar in form, dimensions, and function to the
RCM3305/RCM3315 modules. We strongly recommend that existing RCM3305/3315
customers and designers of new systems consider using the new RCM3309/RCM3319
RabbitCore modules.
This section compares the two lines of RabbitCore modules.
• Temperature Specifications
tured after May, 2008, are specified to operate at 0°C to +70°C. The RCM3309/
RCM3319, rated for -40°C to +85°C, are offered to customers requiring a larger
temperature range after May, 2008.
• Maximum Current
required by the RCM3309/RCM3319.
— The
LEDs SPEED
•
the RCM3305/RCM3315 and the RCM3309/RCM3319, the
combined to one LED on the RCM3309/RCM3319, and the RCM3309/RCM3319 has
an / LED instead of the
FDX COL
on the RCM3305/RCM3315 blinks when data are being written to or read from the
serial flash. The
FDX/COL
Ethernet connection is in full-duplex mode (steady on) or that a half-duplex connection
is experiencing collisions (blinks).
NOTE: The change in LED indicators means that there is no indication on the
RCM3309/RCM3319 when data are being written to or read from the serial flash.
Ethernet chip. A different Ethernet controller chip is used on the RCM3309/RCM3319.
•
The Ethernet chip is able to detect automatically whether a crossover cable or a straight-
through cable is being used in a particular setup, and will configure the signals on the
Ethernet jack interface.
Dynamic C — As long as no low-level FAT file system calls were used in your applica-
•
tion developed for the RCM3305/RCM3315, you may run that application on the
RCM3309/RCM3319 after you recompile it using Dynamic C v. 9.60.
4
— RCM3305/RCM3315 RabbitCore modules manufac-
— The RCM3305/RCM3315 draws 390 mA vs. the 325 mA
and user ( /
USR BSY
LED on the RCM3305/RCM3315. The
SF
LED on the RCM3309/RCM3319 indicates whether the
)LED locations have been swapped between
LNK
RabbitCore RCM3305/RCM3315
/ ACT LEDs have been
LED
SF