Epson EB-Z8355WUNL User Manual page 58

Extended Menu
Sub Menu
Operation
Standby Mode
Air Filter Notice
Multi-Projection
Direct Power On: You can set whether or not (On/Off) to enable Direct Power On.
Be careful when this item is set to On because this unit turns on at the time of power recovery with this unit plugged-in to an outlet.
Sleep Mode: When set to On, this automatically stops projection when no image signal is being input and no operations are carried
out.
Sleep Mode Timer: When Sleep Mode is set to On, you can set the time before the projector automatically turns off within a range of 1 to
30 minutes.
Shutter Button: Select an operation to be done when the [Shutter] button is pressed. When Electric Shutter is selected, the electric shutter
opens/closes. s p.33 When Blank is selected, this turns off the video temporarily.
Shutter Timer: When set to On, this turns off the power automatically 30 minutes after the electric shutter is closed.
Shutter Timer is set to On at the time of purchase. (When Shutter Timer and Sleep Mode are set to On at the same time, Sleep Mode has
priority.)
High Altitude Mode: Set to On when using the projector above an altitude of 1500 m.
BNC Sync Termination: Set the termination for the signal from the BNC input port. This should usually be set to Off. Set to On when
analog (75Ω) termination such as for switchers is necessary.
Remote Control Type: You can select Normal or Simple depending on the type of remote control.
Set this item to Normal to use the remote control provided with the projector. When Simple is selected, you can use the remote control
provided with other Epson projectors to operate this projector. This is useful if you want to use a remote control that you are already
familiar with to operate the projector. (When using the remote control that is supplied with an EB-G5xxx-series or EB-Z80xx-series
projector, select Normal.)
However, you cannot use the remote control provided with this projector if this is set to Simple. Make sure that the setting is correct
because, if the projector is mounted on the ceiling or somewhere hard to reach, changing it back to Normal may be difficult. Additionally,
you cannot use the functions that are not equipped with this projector or the remote control which you use.
Beep: When this is set to On, the confirmation buzzer beeps to notify you that the power turns on or off, the electric shutter opens or
closes, or the cooling down is finished.
You can use the functions that monitor and control the status of the projector over the network even when the projector is in standby mode
if this is set to Communication On.
You can set whether or not (On/Off) to enable Air Filter Notice. When this is set to On and a clog in the air filter is detected, the message
is displayed on the screen.
You can make settings for the useful functions to project images using multiple projectors. s
Brightness Level (EB-Z8455WU/Z8450WU/Z8355W/Z8350W/Z10005/Z10000 only): Set the lamp brightness level between 1 and 5. This item
can be adjusted when Normal 1 is selected in the Power Consumption setting from the Settings menu.
Edge Blending: Corrects a border between multiple images to create a seamless screen. s
Multi-screen: You can adjust the hue and brightness of each projected image. s
Projector ID: Set the ID within a range of 1 to 9. Off indicates that no ID is set. s
Function
p.150
p.155
p.157
p.150
58