Epson EB-Z8355WUNL User Manual page 102

Replacing Consumables
Warning
•
When replacing the lamps because they have stopped illuminating, there is a
possibility that the lamp may be broken. If replacing the lamp of a projector
which has been installed on the ceiling, you should always assume that the
lamp is broken, and you should stand to the side of the lamp cover, not
underneath it. Remove the lamp cover gently.
•
Never disassemble or remodel the lamp. If a remodeled or reassembled lamp is
installed into the projector and used, it could cause a fire, electric shock, or an
accident.
Caution
Wait until the lamps have cooled down sufficiently before removing the lamp
cover. If the lamp is still hot, burns or other injuries may result. It takes about
one hour after the power has been turned off for the lamp to be cool enough.
Procedure
A
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cable.
B
Wait until the lamps have cooled down sufficiently before
removing the lamp cover on the back of the projector.
Pinch the tabs on the front of the lamp cover together to release the
lock. When the lock releases, pull the cover straight out.
C
Pull up the lock lever for the lamp you want to replace and
pull the lamp straight out.
If the lamp is cracked, replace it with a new lamp, or contact your
local dealer for further advice.
A
Lamp 1
102
Epson Projector Contact List
s