Table of Contents
Advertisement
Security Functions
• If Password Protect is already activated, you must enter the
q
Password.
If the Password is entered correctly, the Password Protect setting
menu is displayed. s "Entering the Password"
• When the Password is set, stick the Password protect sticker in a
visible position on the projector as a further theft deterrent.
B
Turn on "Power On Protect".
(1)
Select Power On Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Esc] button.
C
Turn on "User's Logo Protect".
(1)
Select User's Logo Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Esc] button.
D
Turn on "Network Protect".
(1)
Select Network Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Esc] button.
E
Set the Password.
(1)
Select Password, and then press the [Enter] button.
(2)
The message "Change the password?" is displayed, select Yes and then press
the [Enter] button. The default setting for the Password is "0000". Change
this to your own desired password. If you select No, the screen shown in step
1 is displayed again.
(3)
While holding down the [Num] button, enter a four digit number using the
numeric buttons. The number entered is displayed as "* * * *". When you
enter the fourth digit, the confirmation screen is displayed.
p.39
Entering the Password
When the Password entry screen is displayed, enter the Password using the
numeric buttons on the remote control.
Procedure
While holding down the [Num] button, enter the Password by
pressing the numeric buttons.
When you enter the correct Password, projection begins.
Remote Control
(4)
Re-enter the Password.
The message "Password accepted." is displayed.
If you enter the Password incorrectly, a message is displayed prompting you
to re-enter the password.
39
Advertisement
Table of Contents
