Omron K35-2 Manual page 23

■ Power Supply Derating Curve for Sensor (Reference Value)
With 12 V
Max. current (mA)
140
120
100
80
60
40
20
0
−20 −10
0 10 20 30
Ambient temperature (°C)
Note: 1. The above values are for standard mounting. The derating curve differs depending on the mounting conditions.
2. Do not use the Sensor outside of the derating area (i.e., do not use it in the area labeled A in the above graphics). Doing so may occa-
sionally cause deterioration or damage to internal components.
■ Component Names and Functions
Max/Min status indicator
Turns ON when the maximum value or minimum value is
displayed in the RUN level.
Level/bank display
In RUN level, displays the bank if the bank function is
ON. (Turns OFF if the bank function is OFF.)
In other levels, displays the current level.
Comparative output
status indicators
Display the status of comparative outputs.
Status indicators
Function
Display
Turns ON when the tare zero function is
T-ZR
executed. Turns OFF if it is not executed or
is cleared.
Turns ON when the forced-zero function is
Zero
executed. Turns OFF if it is not executed or
is cleared. (Excluding the K3HB-H.)
Turns ON/OFF when hold input turns
Hold
ON/OFF.
MAX/MIN Key
Used to switch the
display between the
PV, maximum value,
and minimum value and
to reset the maximum
and minimum values.
22
Digital Indicators
With 10 V
Max. current (mA)
140
1
120
100
80
60
40
20
0
−20
40 50 60
HH Max
Min
H
P
L
L
T-ZR CMW
LL
Zero Hold
MAX/MIN LEVEL
LEVEL Key MODE Key
Used to switch the
Used to switch level.
parameters displayed.
K3HB-X/-V/-H/-S
1
−10
0 10 20 30 40 50
Ambient temperature (°C)
TG HH H
T LL L
MODE SHIFT UP
SHIFT Key
Used to change
parameter settings.
When changing a set
value, this key is used
to move along the
digits.
60
PV display
Displays PVs, maximum values,
minimum values, parameter
names, and error names.
Position meter
Displays the position of the PV with
respect to a desired scale.
SV display
Displays SV and monitor values.
SV display status indicators
Display Function
Turns ON when the timing signal turns
TG
ON. Otherwise OFF.
Turns ON when parameters for which
T
teaching can be performed are
displayed.
In RUN level, turn ON when the
HH, H,
comparative set values HH, H, L, and
L, LL
LL are displayed.
UP Key
When changing a set value,
this key is used to change
the actual value.
When a measurement value
is displayed, this key is
used to execute or clear the
forced-zero function or to
execute teaching.