System Configuration - Omron V640-HAM11-V3 User Manual

SECTION 1
Product Outline

System Configuration

When SECS Is Used
Communications with the host device is possible using the SECS protocol.
Host
Host
This is a host computer,
equipment controller, etc.
When SECS Is Not Used
Communications with the host device follow the OMRON proprietary protocol.
The Amplifier Units are connected directly to the host device without using a CIDRW Controller.
Host
Host
This is a host computer,
equipment controller, etc.
Refer to the following page for connection examples for more than one Amplifier Units or for connection examples for
using the V700-L11 Link Unit.
Using Link Units (V700-L11) to make connections makes it possible to remove and replace just the rele-
vant Amplifier Unit while leaving the power to the CIDRW system on in the event of a failure or during
maintenance.
CIDRW System
18
User's Manual
CIDRW Controller
V700-L22
RS-232C
SECS I/II
CIDRW Controller
V700-L22
RS-232C
SECS I/II
Multiple Amplifier Units
are controlled in
response to commands
(SECS) from the host
device.
RS-232C
OMRON proprietary protocol
RS-232C
OMRON proprietary protocol
page 119
Amplifier Unit
V640-HAM11-V3
RS-232C
Amplifier Unit
V640-HAM11-L
RS-232C
The Amplifier Units con-
trol the CIDRW Heads.
Amplifier Unit
V640-HAM11-V3
Amplifier Unit
V640-HAM11-L
The Amplifier Units con-
trol the CIDRW Heads.
CIDRW Head
V640-HS61
CIDRW Head
V640-HS62
The CIDRW Heads are the
antennas for reading the
carrier IDs from the ID Tags
and writing the carrier IDs.
CIDRW Head
V640-HS61
CIDRW Head
V640-HS62
The CIDRW Heads are the
antennas for reading the
carrier IDs from the ID Tags
and writing the carrier IDs.