Table of Contents
Advertisement
4. Press the down arrow button to select Media Adjust and press the OK button.
5. Press the down arrow button to select Manual and press the OK button.
6. Press the OK button to select Feed Adjustment.
7. Press the up or down arrow button to select an adjustment pattern and press the OK button.
• 500mm Pattern: We recommend starting with this pattern. Make sure the length of the loaded
media is at least 38 inches (970 mm).
• 250mm Pattern: Make sure the length of the loaded media is at least 28 inches (720 mm).
• 100mm Pattern: Make sure the length of the loaded media is at least 22 inches (570 mm).
• Standard: Make sure the length of the loaded media is at least 13 inches (330 mm).
Your product prints an adjustment pattern and automatically feeds the media to viewing position.
8. Do the following to adjust the media feed:
• If you selected 500mm Pattern (recommended), 250mm Pattern, or 100mm Pattern, measure
the distance between the + symbols in each test pattern as shown.
On the product control panel, enter the value for the distance between the + symbols and press
the OK button.
49
Advertisement
Table of Contents
