Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Switching on/off the projector
Connecting the power cord
Make sure that the supplied power cord is securely fixed to the <AC IN> terminal of the projector body to
prevent it from being removed easily.
Confirm that the <MAIN POWER> switch is on the <OFF> side before connecting the supplied power cord to the
projector.
Use the power cord matching with the power supply voltage and the shape of the outlet.
For details of power cord handling, refer to "Read this first!" (x page 5).
Note
f The supplied power cords vary depending on the country or region where you purchased the product.
How to attach the power cord
For Taiwan
1)
Check the shapes of the <AC IN> terminal at the rear of the projector and the power cord connector,
and insert the connector completely in the correct direction.
For other countries or regions
1)
Check the shapes of the <AC IN> terminal at the rear of the projector and the power cord connector,
and insert the connector completely in the correct direction.
2)
Make sure that the tabs on the left and right sides of the connector are securely engaged with the
lugs of the <AC IN> terminal.
Attention
f Do not use the power cord with its tabs damaged. Doing so may result in a poor contact between the power cord connector and the <AC
IN> terminal. Consult your dealer for repairing the power cord.
How to remove the power cord
For Taiwan
1)
Confirm that the <MAIN POWER> switch at the rear of the projector is set to <OFF> side, and remove
the power plug from the outlet.
2)
While holding the power cord connector, pull out the power cord from the <AC IN> terminal of the
projector.
For other countries or regions
58 - ENGLISH
Advertisement
Table of Contents
