Table of Contents
Advertisement
Chapter 5 Operations — Projecting with MEMORY VIEWER input
g The [NETWORK/USB] menu → [MEMORY VIEWER] → [AUTOPLAY] (x page 147) is set to [ON]
f The input is set to MEMORY VIEWER when the power is turned on to start projection
g The [PROJECTOR SETUP] menu → [STARTUP INPUT SELECT] (x page 117) is set to [MEMORY
VIEWER]
g The [PROJECTOR SETUP] menu → [STARTUP INPUT SELECT] (x page 117) is set to [LAST USED], and
the power is turned off with the input set to MEMORY VIEWER
f There are still image/movie files that can be played back with the Memory Viewer function in the root folder of
the USB memory
Note
f The playback order follows the display order set in the [NETWORK/USB] menu → [ [MEMORY VIEWER] → [SORT] (x page 147).
Also in the cases where still image and movie files both exist in the same folder, they are played back according to the [SORT] setting.
f To play back still image/movie files automatically when the projector is switched on, perform the following setting and operation.
g Set the [PROJECTOR SETUP] menu → [INITIAL STARTUP] (x page 117) to [ON]
g Set the [PROJECTOR SETUP] menu → [INITIAL STARTUP] (x page 117) to [LAST MEMORY], and turn off the circuit breaker while
projecting or disconnect the plug of the power cord while projecting
192 - ENGLISH
Advertisement
Table of Contents
