Switching On/Off The Projector; Connecting The Power Cord - Panasonic PT-VMZ40 Operating Instructions Manual

Switching on/off the projector

Connecting the power cord

Make sure that the supplied power cord is securely fixed to the projector body to prevent it from being removed
easily.
For details of power cord handling, refer to "Read this first!". (x page 4)
Attaching the power cord
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the plug completely in the correct direction.
2) Fix the power cord connector to <AC IN> terminal by tightening the fixing screws on both sides of the
power cord connector.
Attention
f If the power cord connector is not fixed to the <AC IN> terminal with the fixing screws or the fixing screws are not tightened securely, poor
contact may occur between the power cord connector and the <AC IN> terminal. Consult your dealer for repairing the power cord.
Removing the power cord
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Loose the fixing screws on both sides of the connector and remove the power plug from the <AC IN>
terminal.
42 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector