Table of Contents
Advertisement
4)
Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
5)
Press as to select [USB MEMORY].
6)
Press the <ENTER> button.
f The [SELECT COPY TYPE] screen is displayed.
7)
Press as to select [USB MEMORY -> PROJECTOR].
8)
Press the <ENTER> button.
f The confirmation screen is displayed.
9)
Press qw to select [OK], and press the <ENTER> button.
f The projector automatically enters standby state and starts copying data from the USB memory to the
projector.
10) Once the copying of the data is completed, disconnect the USB memory from the <VIEWER/PAIRING>
terminal.
11) Turn on the power of the copy destination projector.
f The copied content is reflected on the projector.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq
f While data is being copied, the light source indicator <LIGHT>, the temperature indicator <TEMP>, and the filter indicator <FILTER> of the
destination projector will blink. Make sure that the indicators stop blinking before powering on the projector.
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1)
Press as to select [SAVE ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
f [PROGRESS] is displayed while saving data.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq
f Data set from the computer application is not included in [ALL USER DATA].
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1)
Press as to select [LOAD ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq
f The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f Data registered from a computer is not included in [ALL USER DATA].
130 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Advertisement
Table of Contents
