Table of Contents
Advertisement
[ECO MANAGEMENT]
Set [ECO MANAGEMENT] to reduce the power consumption and enhance the life of the light source.
Setting [LIGHT POWER]
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [LIGHT POWER].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
[QUIET]
[USER]
*1 The runtime is an estimation when the [PICTURE] menu → [DYNAMIC CONTRAST] is set to [2].
f Proceed to Step 5) when [USER] is selected.
5)
Press as to select [LIGHT OUTPUT].
6)
Press qw to adjust.
Operation
Press w.
Press q.
*1 It should be noted that the picture quality tends to deteriorate as the light output decreases.
Note
f Under influences of characteristics of each light source, conditions of use, installation environment, etc., the runtime may be shorter than the
estimation.
f Runtime is a time until the luminance of the light source to become about half when using the projector continuously. The runtime is just an
estimate, and is not the warranty period.
f If the runtime exceeds 10 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
f When anything other than [NORMAL] is set, the setting in the [PROJECTOR SETUP] menu → [LightID] is disabled, and this item is fixed to
[OFF].
Setting [AMBIENT LIGHT DETECTION]
Sets if the [AMBIENT LIGHT DETECTION] function to adjust the light power depending on the brightness of the
installed location is enabled or not.
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [AMBIENT LIGHT DETECTION].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
114 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when high luminance is required. The light power is 100 % and the estimated runtime
is approximately 20 000 hours
The luminance will decrease compared to [NORMAL], but select this item to suppress the reduction in
luminance against the runtime of the light source. The light power is 70 % and the estimated runtime
is approximately 24 000 hours
Select this item to prioritize the operation with low noise. The light power is 70 % and the estimated
runtime is approximately 20 000 hours
Select the item to set the picture brightness as desired.
Brightness
The screen becomes brighter.
The screen becomes darker.
Disables the ambient light detection function.
Enables the ambient light detection function.
.
*1
.
*1
.
*1
Adjustment
Runtime (estimate)
The runtime becomes shorter.
The runtime becomes longer.
Range of adjustment
30 %
- 100 %
*1
Advertisement
Table of Contents
