Table of Contents
Advertisement
Acer S205F / S200F User's Manual
Notes
)
Table 2–4
Column / row
#/1
#/2
#/3
#/4
Important
SES drives: Drive bay set for immediate start, all other bays are delayed spin start (12 seconds x
Module 8 of the SEL_ID) unless there are two active PSUs when they all start immediately.
2.9 Altos S200F Drive Enclosure
Device Addressing
Each enclosure has 16 drive bays. The SEL_ID of each drive is determined by the device slot (0-15) in
which it is installed and the address range setting, which is set by means of the Enclosure ID switch
on the Ops Panel (shown in
are shown in
Table 2–5
Switch Number
1
2
3
4
5 & 6
7 & 8
9 & 10
32
1 Drives are numbered row/column.
2 With only one active PSU the enclosure will take approximately 96 seconds to start
all drives from Power On.
Drive Slot Arrangement: Enclosure Front View
1/#
2/#
Drive 0*
Drive 1
Drive 4
Drive 5
Drive 8
Drive 9
Drive 12
Drive 13
Figure 1–8 on page
Table 2–5
Ops Panel Switch Functions
Function
Not Used
Not Used
Not Used
Not Used
Not Used
Drive Loop Speed
Select
Drive Addressing
Mode Selection
3/#
4/#
Drive 2
Drive 3
Drive 6
Drive 7
Drive 10
Drive 11
Drive 14
Drive 15*
6) at the rear of the enclosure. The switch settings
Recommended Setting
Off
Off
Off
Off
Off
Sw 7
Sw 8
On
Off
Off
Off
Sw 9
Sw 10
On
On
Off
On
Definition
Force 2Gb/s
Force 1Gb/s
Mode 0 (recommended)
Mode 1 (not recommended)
Advertisement
Table of Contents
