Table of Contents
Advertisement
Table 1–3
Altos S205F RAID I/O Module LEDs
LED Functions
Color
Battery Fail
Amber
Expansion Port
Green
Signal Good
RJ45 Ethernet Con-
Green
nection
Green
System
Amber
Cache Active
Amber
Host Port 1
Green
Signal Good
Host port 0
Green
Signal Good
Table 1–4
Altos S200F JBOD I/O Module LEDs
LED
Definition
FC Host Port 0
Incoming FC signal is GOOD.
No connection or incorrect connection
Signal Good
Invalid SFP connection
FC Host Port 1
Not used.
Signal Good
Router Status
Storage Router Device Ready
Storage Router Device not ready or defective
Module Fault
Fault present (also
Successful JBOD I/O module initialization
Description
When ON this LED denotes the following status:
• Battery voltage is lower than 2.5V.
• Battery temperature is abnormal (normal 0° - 45°C on charge
state)
• BBU is not present
When FLASHING, the LED denotes BBU is under charging.
When OFF, the LED denotes BBU charge is done.
When ON this LED denotes that running FC signal is good.
LED1: Static ON while LAN port status is link.
LED2: FLASHING while LAN port status is active.
When ON this LED denotes that the Controller is failed or SES Ser-
vices card is failed.
When ON this LED denotes the following status:
• When system is with power, ON denotes cache memory con-
tains data or ECC errors are detected.
• When system is without power, ON denotes cache memory
contains data and is held up by BBU.
When ON this LED denotes that incoming FC signal is GOOD.
When ON this LED denotes that incoming FC signal is GOOD.
On when booting)
9
Introduction
Color
Normal
Fault Sta-
Status
tus
Green
On
Off
Flashing
Green
On
Off
Flashing
Green
On
Off
Amber
Off
On
Advertisement
Table of Contents
