Table of Contents
Advertisement
Glossary
Glossary
, italics
In glossary definitions
are used for items defined elsewhere in the glossary and bold is used
for the items shown in brackets after the main heading of the entry.
ASCII American Standard Code for Information Interchange. A 7-bit binary code (0's, 1's) used to
represent letters, numbers, and special characters such as $,!, and /. Supported by almost every
computer and terminal manufacturer.
ATA (Advance Technology Attachment)
A disk drive interface standard based on a 16-bit bus
and dealing with the power and data signal interfaces between the motherboard and the
integrated disk controller and drive. The ATA "bus" only supports two devices - master and slave.
Attribute
Setting that controls access to a specific file. Often used to protect important files (such
as the Registry files) from accidental change or deletion. Set using the ATTRIB command in MS-DOS.
Backplane A printed circuit board incorporated in the chassis assembly to provide logic level
signal, and low voltage power distribution paths.
Bay The slot that a unit or media device fits into.
Byte A group of binary digits stored and operated upon as a unit. A byte may have a coded value
equal to a character in the ASCII code (letters, numbers), or have some other value meaningful to
the computer. In user documentation, the term usually refers to 8-bit units or characters.
1 kilobyte (K) is equal to 1,024 bytes or characters; 64K indicates 65,536 bytes or characters.
Cable Throughout this Altos S205F / S200F User's Manual this term is used in accordance with the
preferred US context of: "an insulated flexible electric wire used for the transmission of data signals
between computer equipment."
Note: Cable is UK preferred terminology for either a power cord or a data cable:
Character A representation, coded in binary digits, of a letter, number, or other symbol.
Characters Per Second A data transfer rate generally estimated from the bit rate and the character
length. For example, at 2400 bps, 8-bit characters with Start and Stop bits (for a total of ten bits per
character) will be transmitted at a rate of approximately 240 characters per second (cps).
Chassis A sheet metal enclosure incorporating a Backplane PCB and module runner system. The
chassis contains a number of 'Bays', each of which can accommodate a plug in module. There are
sixteen
drive
carrier bays at the front and five bays at the rear which house two
power supply/
cooling modules,
I/O modules
Ops Panel.
two
and also the
Configure
To set up a hardware device and its accompanying software.
I/O module (Serial ATA RAID or JBOD I/O module) A plug-in module providing FC-AL channel
SATA drives
external cable interface with 16
.
Data Communications A type of communications in which computers and terminals are able to
exchange data over an electronic medium.
43
Advertisement
Table of Contents
