Grizzly G0899 Owner's Manual page 25

6. Inspect extension wings and main table mat-
ing surfaces for burrs or foreign materials that
may inhibit assembly.
For a correct fit, mating edges of table and
wings must be clean, smooth, and flat. If nec-
essary, use a wire brush or file to remove any
flashing, dings, or high spots.
7.
While an assistant holds wings in place,
attach each extension wing to main table
with (3) M10-1.5 x 30 cap screws, 10mm lock
washers, and 10mm flat washers (see Figure
19).
Main Table
x 3
Figure 19. Extension wings installed.
8. Place straightedge across extension wings
and main table to make sure that combined
table surface is flat.
— If combined table surface is flat, skip to
next step.
— If outside end of extension wing tilts down,
place a strip of masking tape along bottom
edge of main table to shim end of exten-
sion wing up (see Figure 20).
Figure 20. Masking tape location for tilting
extension wing up.
Model G0899 (Mfd. Since 10/20)
Figure 21. Masking tape location for adjusting
9.
Extension
Wing
(1 of 2)
— If outside end of extension wing tilts up,
place strip of masking tape along top edge
of main table to shim end of extension
wing down (see Figure 21).
Note: After re-installing wings, remove all
excess masking tape with a razor blade.
the extension wing down.
Attach front rail to table with (2) M10-1.5 x 25
hex bolts, (2) 10mm lock washers, and (2)
10mm flat washers, as shown in Figure 22.
Finger tighten fasteners for now.
Figure 22. Front rail attached to table.
Front Rail
x 2
-23-