Fence Scale Calibration - Grizzly G0899 Owner's Manual

Fence Scale
Calibration
The fence scale indicator window, shown in
Figure 130, can be calibrated with the fence
scale if you notice that your cuts do not accurately
match what is shown on the fence scale.
Indicator Window
Figure 130. Fence indicator window.
The indicator adjusts by loosening the two mount-
ing screws and sliding it in the desired direction.
Tools Needed
Hex Wrench 3mm .............................................. 1
Scrap Piece of Wood......................................... 1
Tape Measure .................................................... 1
To calibrate fence scale indicator windows:
1. Position and lock fence at 13", as indicated
by scale, then cut your scrap piece of wood.
2. Reposition and lock fence at 12", as indicated
by scale.
3. Flip your scrap piece of wood over, placing
side that was cut in Step 2 against fence, and
cut your scrap piece of wood.
4. Measure width of freshly cut workpiece with
tape measure. Workpiece width should be
exactly 12". If it is not, then adjust indicator
window to match the width of workpiece.
-74-
Table/Dado Insert
The table/dado insert must sit perfectly flush with
the table to provide a smooth, continuous surface
for the workpiece to slide over. The insert is held
in place by a magnet and sits on top of four adjust-
ment screws (see Figure 131).
The insert should be checked and adjusted any
Screws
time it is removed and replaced, after prolonged
use, or any time you notice the workpiece or fence
does not slide smoothly over the insert.
Figure 131. Location of table/dado insert holes
Qty
Tools Needed
Hex Wrench 3mm .............................................. 1
Straightedge ...................................................... 1
To check and adjust insert:
1.
DISCONNECT MACHINE FROM POWER!
2.
Place straightedge across insert and check
to make sure insert is flush with table at front
and back of throat.
— If insert is flush with table, no adjustments
— If insert is not flush with table, proceed to
3. Insert hex wrench through holes shown in
Figure 131. Loosen screws to raise insert, or
tighten screws to lower it.
4. Repeat Steps 2–3 until insert is flush.
Adjustment
with adjustment screws.
are necessary.
Step 3.
Model G0899 (Mfd. Since 10/20)
Qty