Grizzly G0899 Owner's Manual page 48

Making Resaw Barrier
When resawing, the resaw barrier acts in tandem
with the rip fence to provide tall support for the
workpiece. This minimizes the probability of it
binding against the blade and causing kickback.
Tools Needed:
Table Saw ..........................................................1
Jointer and Planer ....................... Recommended
Clamps ............................................... 2 Minimum
Drill ....................................................................1
Drill Bits ⁄ ", ⁄ " ....................................... 1 Each
1 9
8 64
Countersink Bit ...................................................1
Components Needed for Resaw Barrier:
Wood* ⁄ " x 5 ⁄ " x Length of Fence ...................1
3 1
4 2
Wood* ⁄ " x 3" x Length of Fence ......................1
3
4
Wood Screws #8 x 2" ........................................4
Wood Glue .........................................As Needed
*Only use furniture-grade plywood, kiln-dried
hardwood, or HDPE plastic to prevent warping.
To build a resaw barrier:
1. Cut your wood pieces to size specified above.
If you are using hardwood, cut pieces over-
size, then joint and plane them to correct size
to make sure they are square and flat.
2.
Pre-drill and countersink four holes approxi-
mately ⁄ " from bottom of 5
3
8
3.
Glue end of 3" board, clamp boards at a 90°
angle with larger board in vertical position, as
shown in Figure 73, then fasten together with
wood screws.
#8 x 2"
Wood Screw
⁄ "
3
4
Figure 73. Resaw barrier.
-46-
Qty
⁄ " tall wood piece.
1
2
⁄ "
3
4
Assembled
Resaw Barrier
Making Auxiliary Fence
An auxiliary fence is necessary if you are resawing
a workpiece that is taller than it is wide. The fence
should be no less than
to be resawn.
The fence should be similar to the one in Figure 74
when installed.
Assembled Auxiliary Fence
Figure 74. Example of auxiliary fence attached
to Model G0899 fence face.
Tools Needed:
Clamps ...............................................................2
Drill ....................................................................1
Drill Bit ⁄ " ........................................................1
7
32
Countersink Drill Bit ............................................1
Hex Wrench 5mm ...............................................1
Ruler ...................................................................1
Model G0899 (Mfd. Since 10/20)
⁄ " shorter than the board
1
2
Qty